The PadPuls converter is used whenever necessary to convert pulse outputs from water meters, gas and electrometers to the M-Bus bus. The converter is made in multiple versions depending on how many pulse inputs you can connect to it. The configuration is completely identical for all variants. The maximum number of entries is 4. Necessary resources Install MBCONF software on your PC / Laptop. Connect M-Bus Micro-Master to a free USB port on the computer, such as COM6 (see image).

You will use the M-Bus splitter if you want to read counters simultaneously from two central units (M-Bus Master). Typical examples of using heat distribution meters (city heating plants) that have been equipped with an M-Bus output for CHP and want a meter of such characteristics connected with the Enectiva system. In this case it is necessary to divide the M-Bus output from the meter into two M-Bus outputs. The M-Bus splitter can separate a bus with a maximum of 4 M-Bus counters.

The following steps will guide you through the installation and configuration of the components needed to properly install your HRI-B sensor. Steps to configure your HRI-B sensor Install the MiniCom3 software on your PC / Laptop. Connect the M-Bus Micro-Master to a free port on your computer, such as COM6 (see image). Use the Device Manager on the computer to configure the appropriate port, ie in our case it is COM6.