The Loratech S0 Node is used to read meter pulses and send the recorded data over the LoRaWAN wireless network. Connection INx pulse inputs The pulse outputs of the meter are connected to the INx terminals. They are occupied from IN0 to IN3. It is always important to observe polarity, i.e. connect the + of the counter to the + of the meter. IN0 (P1) - counter 0 IN1 (P2) - counter 1 IN2 (P3) - counter 2 IN3 (P4) - counter 3 Configuration interface Switch the USB- UART converter to 3.

You will use a passive splitter if you want to divide one input pulse signal into two identical ones. We use it mostly in case we need to share the meter data with a third party. Typically, these are gas and waterworks, where one distributor from the hub will be used by the distributor and the other by us in Enectiva. The converter can then be connected to an M-Bus converter (eg Pad Pulse) or converted to wireless eg via WMBUS 169, Wmbus 868 etc.

The following guidelines must be followed when installing Enectiva projects: In general When replacing meters or installing new ones, a protocol of replacement (new / old states, etc.) will always be filled. It is necessary to write serial numbers of old and new meters, serial numbers of M-bus modules. After installation of any meter, installation of the meter with digital output or installation of the central unit, photo documentation of the site will be made.

This manual serves as a standard for energy system designers and designers using M-Bus technology. The aim of this standard is to enable clear and transparent allocation of energy consumption to technological units (heating, cooling, ventilation, production, lighting, etc.) or to economic units (tenant, economic center, etc.). Furthermore, the aim of this standard is to prepare the entire measurement system for automatic data collection from individual meters, possible identification of …

Pulse output settings to change the configuration, the switches on the inside of the machine door must be switched to the top position Place the read head on the viewport next to the keyboard on the front of the device connect the read head cable to the USB port of the computer in the Device Manager (click Start, type Device Manager in the Search Programs and Files box and open it) check the assigned port number in the COM and LPT Ports section - COM20 in our case Open TELVES In the Measured …

For sensing pulses from the RVG rotary gas meter, an INS-W11 6-pin connector is used. The pins on the connector are shown in the following figure: The pulse output is on pins 1 (+) and 2 (-), the pulse value is 10 pulses / m3 for G10-G65, 1 pulse / m3 for G100-G250.